Valley Vflex, Руководство пользователя, Страница: 19 / 38

19
Overview
Time
Displays the current time according to the clock in the
VCS computer.
If the current time is 1:45:00 P.M., it appears on
the screen in the 24-hour format as 13:45:00
(hh:mm:ss). See Figure 19-1.
Corner Angle (CANGLE)
Displays the current corner angle (CANGLE) as
measured by the corner angle sensor, in degrees.
Error Code (Exx)
This field displays any currently active error codes.
The error code field (Exx) appears only when a
system error has occurred. If multiple errors occur
the error codes will cycle on the display once every
two seconds. Error codes E03-E13 will not appear.
See Figure 19-1.
Active error codes can be acknowledged and cleared
from the status screen by viewing them in the
Diagnostics Screen.
Speed
Displays the current measured percent timer setting
(SPEED:xxx%) from the smart tower board in the
VCS control panel. See Figure 19-1.
Main Status Menu
The VCS control panel display is used to show current status and information for programming and selecting
functions. When the control panel main disconnect is turned on and at all other times when the operator is not
programming the control panel, the control panel display shows the current machine status on the status screen.
See Figure 19-1. A short explanation of the status screen elements is given below and on the following pages.
NOTE
• This Status Screen example
illustrates the operating
conditions of a typical irri-
gation machine. The Status
screen of your machine will
show different conditions.
Date
Displays the current date according to the clock in
the VCS computer.
If the current date is August 18, 2013, it appears
on the screen as 08/18/13 (mm/dd/yy). See Figure
19-1.
Machine Angle (MANGLE)
Displays the current machine angle calculated from
the GPS position. If the machine angle is not valid,
"---" will be displayed. If GPS is not enabled, " " will
be displayed. See Figure 19-1.
Adjusted Speed
Displays the adjusted speed being sent to the Last
Regular Drive Unit (LRDU) when the pressure or
chemigate mode are selected.
SOL#
Displays active solenoids 1-9 on row 4.
TEN+
Displays active solenoids 10-16 on row 4.
hh:mm:ss CANGLE : 165 DEG Exx SPEED : xxx%
mm/dd/yy MANGLE : 303 DEG ADJ SPEED : xxx%
SOL# TEN+ P : XXX PSI DIR : XXX EG : OFF
1234567890123456 MODES: CHEM ANGLE
2
9
1
3
4 5
6
8
7
10
11
Figure 19-1 1. Control Panel Display
2. Default Status Screen
3. Time
4. Corner Angle
5. Error Code (Exx)
6. Speed:xxx%
7. Date
8. Machine Angle 9. ADJ Speed:xxx%
10. SOL#
11. TEN+