VALCO MELTON VCX, Руководство по обслуживанию

Страница: 82 / 213

Section 5 - Operation MC083 - VCX Service Manual
82
Power Up Sequence - Continued
4. The Standby LED on the OT-120 Control will turn orange as the unit warms up (see Figure 5-1).
5. The Standby LED on the OT-120 Control will turn green when the unit is at full power (see Figure 5-1).
See the MC076 Manual for complete operation instructions using the
OT-120 Control/CartonPRO Software with the VCX System
Power Down Sequence
The power down sequence is as follows:
1. Press the Power Off Button on the bottom right of the OT-120 screen (see Figure 5-1).
2. Confirm exit when the Dialog Box appears.
3. Wait until the standby LED on the OT-120 Control turns orange as the unit powers down (see Figure 5-1).
4. Flip the power switch on the back of the VCX Power Supply Module to the “Off” position (see Figure 5-2).
Notes regarding OT and TCM
Things to consider for OT and TCM:
The OT should detect if there are no Inspection channels enabled, but the Ejector is enabled. If this is true, the OT will
set 3400.5F = 1 on the TCM. This will force all products to be ejected and counted as bad products. When the Ejector
is then turned off, or if an Inspection channel is turned on, the OT will set 3400.5F = 0 on the TCM back for normal
operation.
This is to prevent an operator from inadvertently turning off inspection while the Ejector is active.