VALCO MELTON VCX, Руководство по обслуживанию

Страница: 64 / 213

Section 4 - Setup MC083 - VCX Service Manual
64
Add Modules
To add a module, do the following:
1. Turn off all power to the unit and disconnect the power cord from the power source.
2. Remove the cover from the VCX Control as described in this section.
CAUTION! Do not apply excessive force and do not use tools to seat the module! Damage to the
equipment may result.
3. Slide the module into the VCX Control base as shown in Figure 4-2.
Make sure the module slides in easily. Pay attention to the connector
and make sure the locator pin matches up with the mating connector.
Figure 4-2. Adding/Removing a Module
4. Secure the module to the base rails with the screws located on both sides of the module (see Figure 4-2).
5. Connect the appropriate cables/plugs on the back of the module, using the guides in Section 3 - Basic
Features.
6. Reconnect the power cord and follow the powering up sequence.