Vaillant ecoTEC exclusive 835, Инструкция по установке и обслуживанию

Страница: 48 / 72

48
Installation and maintenance instructions ecoTEC exclusive 0020193968_05
Code Parameter
Values
Unit Increment, select, explanation
Factory
setting
Own
setting
Min. Max.
D.005 Heating target flow temper-
ature Current value °C Target flow temperature value (or
target return value)
–
Not ad-
justable
D.006 Outlet temperature target
value Current value °C Domestic hot water temperature
target value (only products with in-
tegrated domestic hot water gener-
ation)
–
Not ad-
justable
D.007 Cylinder temperature tar-
get value
Comfort mode target value Current value °C Only products with integrated do-
mestic hot water generation
Only products with no integrated
domestic hot water generation and
with a connected cylinder
–
Not ad-
justable
D.008 Controller 3-4 Current value
–
0: Open (Room thermostat at ter-
minal RT open = No heat require-
ment)
1: Closed (Room thermostat at ter-
minal RT closed = Heat require-
ment)
–
Not ad-
justable
D.009 eBUS controller target
value Current value
–
Target value from external eBUS
controller
–
Not ad-
justable
D.010 Internal pump Current value
–
0: Off
1: On
–
Not ad-
justable
D.011 External pump Current value
–
0: Off
1: On
–
Not ad-
justable
D.012 Cyl. charging pump Current value
–
0: Off
1: On
–
Not ad-
justable
D.013 Circulation pump Current value
–
0: Off
1: On
–
Not ad-
justable
D.014 Pump speed target value Current value % Target value of internal high-effi-
ciency pump. Possible settings:
0 = Auto
1 = 53
2 = 60
3 = 70
4 = 85
5 = 100 0 = Auto
D.015 Pump speed actual value Current value % High-efficiency pump
–
Not ad-
justable
D.016 Controller 24 V DC: Heat-
ing mode Current value
–
Heating mode
0: Off
1: On
–
Not ad-
justable
D.017 Control type 0 1
–
Heating flow/return temperature
control changeover
0: Flow
1: Return (conversion for underfloor
heating)
If you have activated the return
temperature control, the function
for automatically limiting the heat
output using the volume flow re-
mains active. The partial heat load
that is selected under
D.000 ( auto
= max.) continues to be the upper
limit.
0