10
Installation and maintenance instructions ecoTEC exclusive 0020193968_05
Information on the
identification plate
Meaning
2H, G20
–
20 mbar
(2.0 kPa)
Gas group and gas connection pressure
as set at the factory
ww/yyyy
Date of manufacture: Week/year
Cat.
Approved unit categories
Types
Approved gas-fired units
PMS
Permissible total overpressure in heating
mode
PMW
Permissible total overpressure during hot
water generation
T
max.
Max. flow temperature
ED 92/42
Current efficiency directive fulfilled with
4* rating
V Hz
Mains voltage and mains frequency
W
Max. electrical power consumption
IP
Level of protection
Heating mode
Hot water generation
P
Nominal heat output range
Q
Heat input range
D
Nominal hot water draw-off rate
Bar code with serial number,
7th to 16th digit = product article number
5.4
Product design
1
2
21
4
3
5
6
7
8
9
10
11
12
13
14
20
15
16
17
18
19
1
Flue gas measuring
stub pipe
2
Connection for the flue
pipe
3
All-gas sensor
4
Expansion vessel
5
Water hammer arrester
6
Fan
7
Secondary heat ex-
changer
8
Automatic air vent
9
Pressure gauge
10
Expansion relief valve
11
High-efficiency pump
12
Diverter valve
13
Bypass valve
14
Electronics box
15
Gas valve
16
Compact thermal
module
17
Heat exchanger
18
Ignition electrode
19
Air intake pipe
20
Water pressure sensor
21
Volume flow sensor
5.5
Serial number
The serial number can be found on a plastic label behind the
front flap and on the identification plate.
Note
The serial number can also be shown on the
display of the product (
→
Operating instructions).
5.6
Safety Devices
5.6.1
Electrical Supply Failure
The boiler will not work without an electrical supply. Normal
operation of the boiler should resume when the electrical
supply is restored.
Reset any external controls, to resume normal operation of
the central heating.
If the boiler does not resume normal operation press the
reset button. If the boiler does not resume normal operation
after this call your Installation/Servicing company or Vaillant
service.
5.6.2
Overheating Safety
The boiler software is designed to recognise the potential for
an overheat lockout and will shutdown before this happens.
To restart the boiler, press the reset button on the boiler
interface.
If the boiler fails to resume normal operation and all external
controls are calling for heat, then call your Installation/ Servi-
cing company or Vaillant service.
5.6.3
Frost protection
The appliance has a built in frost protection device that pro-
tects the boiler from freezing. With the gas and electric sup-
plies ON and irrespective of any room thermostat setting, the
frost protection device will operate the pump when the tem-
perature of the boiler water falls below 12 °C.
A timer is used so that the temperature can be checked peri-
odically. After 10 minutes the pump will be stopped if the
temperature is higher than 10 °C or has already reached
35 °C. The burner will activate if the boiler temperature does
not reach 10 °C after 30 minutes or at any time if the temper-
ature drops to 5 °C.
The burner will switch off when the temperature reaches
35 °C.
5.6.4
Condensate Drain Blockage
As a safety feature the boiler will stop working if the con-
densate drain becomes blocked. During freezing conditions
this may be due to the forming of ice in the condense drain
external to the house. Release an ice blockage by the use
