Vaderstad Rexius Twin Series, Инструкция по эксплуатации

Страница: 20 / 28

Service and maintenance
20 14.04.2014
ver. 2
4 Service and maintenance
Figure 4.1
!
All maintenance and service work should only be done when the implement has been lowered
to the ground. Never work under the implement unless it has been properly secured using tres-
tles or similar firm supports. Also be sure to block the lifting ram of the transport wheels using
the yellow locking device (C). Secure the locking device using a cotter and locking pin.
4.1 Regular maintenance
!
Grease the implement according to the grease table intervals, and always prior to and after win-
ter storage and high-pressure water cleaning.
!
Regularly check the tyre pressure. See ”5.2 Technical data” on page 26
!
Prior to winter storage, grease the ram rods.
!
Prior to driving, check that all bolts and nuts are tightened (this does not apply to bolts of flex-
ible joints). During the season, make it a habit to regularly check that all bolts and nuts are
tightened.
Figure 4.2 Figure 4.3
Table 4.1 Lubrication chart
Lubrication points Interval (ha)
Roller bearings 500
Wheel hub 500
Parallellogramme of pre-implements 500
A