Vaderstad Cultus Series, Инструкция по эксплуатации

Страница: 9 / 42

CS 300-400
11.07.2011
ver.3 9
1.3 Other safety regulations
! VERY IMPORTANT! Retighten screw connections according to the table. See “1.4 Retight-
ening of screw connections” see page 11 .
• As the implement is heavy, front counterweights should normally be mounted on the tractor.
Always ensure that the tractor has a sufficient load on the front axle for safe driving.
Figure 1.4
• Take great care when dismantling the cultivator tines’ springs! They have a very large inherent
spring force. See “4.6 Dismantling the parts in the cultivator tine suspension system” see page
35 .
• Check that the tractor’s tyres and wheels are adapted for the weight of the implement and that
the air pressure in the tyres is correct. Note that there is a high load on the tractor’s rear axle,
particularly during road transport. It is therefore necessary to check that the maximum permit-
ted axle load is not exceeded. The implement’s hitching weight on the tractor is indicated in
“6 Technical data” see page 38 .
• Prior to transport on public roads, remove dirt that may fall off from both the tractor and im-
plement.
• Observe great caution when transporting the implement on public roads. Pay attention to the
width and turning area of the implement during transport. Check the position of the tractor
rearview mirrors. Also check that the tractor’s slow vehicle sign is visible above the imple-
ment. The owner/operator is solely responsible for transport of the implement on public roads.
• Prior to transport, fold in the levelling unit’s outer discs in order to reduce the transport width
to less than 3.0, 3.5 and 4 metres respectively.
• Use the lights on the implement in accordance with local traffic regulations.
• Keep in mind that the implement is heavy and, as a result, the braking distance is longer.
• Trailed cultivators may be transported at a maximum speed of 25 km/h on public highways.
When transporting on uneven roads, the transport speed should be reduced.
• When transporting trailed cultivators, all the spacers must be mounted on the ram rod.
• Note that the owner/operator has sole responsibility for complying with national traffic regu-
lations when driving on public roads.
• Prior to connecting the hydraulic hoses, make sure the male couplings on the implement and
the female connectors on the tractor are clean and free from dirt.
• Always use Väderstad original spare parts to maintain the quality and reliability of the imple-
ment. If other makes of spare parts are used, all guarantee and claims commitments cease to be
valid.
• Never dismantle a roller ring unit with steel rings. The unit has been pressed together with a
force of 4 tonnes and there is a high risk of injury if attempts are made to disassemble the unit.
If there should ever be a need for disassembly, please contact the dealer as special tools are
required.