Vaderstad Cultus Series, Инструкция по эксплуатации

Страница: 16 / 42

Instructions and settings
16 11.07.2011
ver. 3
2.2 Hitching and unhitching the implement
Figure 2.1
2.2.1 Hitching
Hitch the implement to the tractor and connect any hydraulic hoses. Do not stand between the trac-
tor and the implement when the tractor is being reversed to hitch the implement!
2.2.2 Unhitching
When unhitching the machine, it is important to ensure that all the tines have roughly the same
load in order to avoid the tips being broken off.
7 Lower the implement onto a flat, stable surface. The implement rests on the tips of the tines
and the compaction roller.
8 Disconnect the three-point couplings.
Trailed machine with all supplied clips on the ram rod as a traffic safety catch must first be raised
to full lifting height. This is done to remove the clips so that the machine can be parallel with the
ground. It is important to ensure that all the tines have roughly the same load in order to avoid the
tips being broken off.
1 Lower the implement onto a flat, stable surface.
2 Depressurise the implement’s hydraulic system by using the float position on the tractor’s hy-
draulic control. The implement then rests on the tips of the tines and the compaction roller.
3 Disconnect the hydraulic hoses and the three-point connections.