Vaderstad Carrier X Series, Инструкция по эксплуатации

Страница: 23 / 48

CRX 425-625
01.05.2015 1
23
2.6 Switching to transport mode
1 Lift the implement using the hydraulic arms. The implement must be lifted to a height that is
sufficient to allow folding to be done unhindered!
2 Fold in the wing sections using the hydraulic system.
3 Check that both wing sections are secured in position by the lock hooks.
Figure 2.11
4 Lift the implement so that there is sufficient ground clearance for transport driving. If sufficient
lifting height cannot be achieved, the implement must be set down on a flat, stable base. The
hydraulic arms must then be moved to a lower hitching point on the implement. Also see
“2.4.2
Hitching point for hydraulic arms” on page 20 .
! Check the transport height! This particularly applies to CRX 625. In some countries, there is a
maximum transport height of 4m.
Figure 2.12
Max 4m