vacuubrand VACUU-PURE 10C, Инструкция по эксплуатации

Страница: 55 / 96

55 20901224_EN_VACUU·PURE 10C_V1.8_221122
Commissioning (operation)
5.4.2 5.4.2 Operation with VACUU·BUS accessories Operation with VACUU·BUS accessories
Operation with in-line solenoid valve
ƒ
The in‑line solenoid valve automatically opens 10 seconds after
the start button is pressed. The value of the waiting time can be
set via the Modbus RTU protocol: 0 – 3600 seconds.
ƒ
The in‑line solenoid valve closes immediately after pressing the
stop button or the regeneration button.
Operation with coolant valve
ƒ
Use a coolant valve when operating with a vapor condenser
and water cooling.
ƒ
The coolant valve automatically opens after pressing the start
button.
ƒ
After pressing the stop button or the regeneration button, the
coolant valve closes automatically after the run‑on time has
elapsed. The factory default run‑on time is 300 seconds, the
value of the run‑on time can be set via the Modbus RTU protocol:
0 – 3600 seconds.
ƒ
Pressing the stop button again in stop mode resets the coolant
valve run‑on time; the run‑on time starts again.
ƒ
Pressing the regeneration button again in regeneration mode
resets the coolant valve follow‑up time; the run‑on time starts
again.
Operation with level sensor
ƒ
The level sensor monitors the liquid level in the receiving flask
of the vapor condenser or separator.
ƒ
The level sensor triggers as soon as the liquid level in the piston
reaches the height of the sensor, a warning is displayed.
ƒ
When a warning message is displayed, a delay time of 300
seconds starts running at the same time. The value of the delay
time can be set via the Modbus RTU protocol: 0 – 3600 seconds.
ƒ
By pressing the start button again in start mode, the delay time
of the level sensor is reset, the delay time starts again.
Operation with
in‑line solenoid
valve
Operation with
coolant valve
Operation with level
sensor