06
Precautions for Use
Before putting articles into the equipment, please make sure that the temperature
in the storage room has reached the set temperature, and then put the articles in
batches. The volume of the articles in the box should not exceed 1/3 of its volume
at a time to prevent the temperature from rising too much.
The temperature display value of the equipment is to show the temperature at
the temperature sensor in the storage room. There is a certain gap between the
displayed temperature and the actual temperature at the center of the equipment
when the equipment just runs, but as the equipment enters a stable state, the
displayed temperature will gradually approach the actual temperature.
The equipment box body is provided with a detection hole so as to lead out the
test line in the box during the test. After the test line is led out, it is necessary to
plug the test hole with insulating material again, otherwise the temperature in
the box may not reach the set temperature value, and condensation will appear
around the outside of the through hole.
Please use diluted neutral cleaner to clean the equipment, and do not use
brushes, acid, gasoline, soap powder, polishing agent or hot water to clean
the equipment, otherwise the painted surface and plastic rubber parts may be
damaged. Attention: Do not use volatile solvents such as gasoline to clean plastic
and rubber parts.
When the device is not in use for a long time, cut off the power supply and turn off
the battery.
Each time you access the items, please try to reduce the time to open the door to
avoid large fluctuations in temperature and humidity inside the box.
After the door is opened, the temperature inside the box will rise sharply in a short
time. This is normal, and the situation will be restored within 1 hour after the door
is closed.