ENGLISH
- 46 -
25.4 - READING THE CYCLE COUNTER
The HEAVY2 unit takes into account the completed opening
cycles of the door and, if requested, reports the need for
maintenance after a fixed number of manoeuvres.
There are two counters available:
• Non resettable counter of the opening cycles completed
(
Total
)
• Counter showing the cycles to be performed before the next
maintenance (
Service
)
This second counter can be programmed with the desired
number of cycles.
1.
Press and hold the
OK
button until the display shows
CNT
2.
Release the
OK
button: the display shows
Total : 0
Service : ----
3.
To activate the maintenance request select the
Service
function and press
OK
4.
Set the desired number of cycles (the step consists of 250
cycles)
5.
Press
OK
to confirm the display shows the control panel
When the
Service
counter reaches
0
the unit sends the
request for maintenance, that can also be signalled in two ways:
1.
Warning light
: the option relay REL2 closes to activate a
warning light (Chapter 23)
2. Pre-flashing
: if you do not connect a dedicated warning light
the unit indicates the request for service through an additional
pre-flashing of 5 seconds at the beginning of each opening
cycle
To disable the signalling it is necessary to access the
Service
counter menu and again program the number of cycles after
which the maintenance will be required.
If set to
0
, the signalling function for the request for service is
disabled and the signal is not repeated.
m
WARNING: maintenance operations should only be
carried out by qualified staff.
25.5 - PROGRAMMAZIONE DEI PARAMETRI DI
FUNZIONAMENTO
1.
Press and hold the
OK
button until the display shows
PRG
2.
Release the
OK
button: the display shows:
• the first parameter of the programming menu:
MODE
• the currently set value (
STAN
)
• a scroll bar useful for detecting the position of the
parameter within the programming menu
• a message describing the parameter
MODE
STAN
3.
To change the value of this parameter press the
OK
button:
the arrows move to the the value
MODE
STAN
4.
Select the desired value using the buttons
h
and
i
5.
Press the
OK
button to confirm and exit the parameter.
The display shows again:
MODE
STAN
6.
Using the buttons
h
i
and
OK
select and edit the necessary
parameters: the following pages show a table with all
programming values, the selectable values. the values set by
DEFAULT and a short description of the function.
NOTE
: If you hold the buttons
h
or
i
the items of the
configuration menu scroll in a fast way, until the item
FINE
is
displayed
m
The last menu item
FINE
stores the changes made, exit
the programming menu and return to normal operation of the
system.
To avoid losing your configuration is mandatory to exit from the
programming mode through this menu item.
m
CAUTION: if you do not carry out any operation for
more than 1 minute, the unit exits from the programming
mode, without storing the settings and changes made are
lost.
Working mode
