V2 CITY1-EVO, Руководство пользователя

Страница: 56 / 124

ENGLISH
- 54 -
PARAMETER VALUE DESCRIPTION
AntE SCor
MEMO
SPiA
Low voltage lights
This menu allows setting the operation of the low voltage lights
output
no no
no
Function deactivated
W.L.
Indicator light operation: Indicates the status of the gate in real-time.
The type of blinking indicates the four possible conditions:
- GATE STOPPED: Light off
- GATE IN PAUSE: the light is on, fixed
- GATE OPENING: the light blinks slowly (2 Hz)
- GATE CLOSING: the light blinks quickly (4 Hz)
FLSh
Flashing light operation (fixed frequency)
LP.PA
Flashing light during pause time
no no
no
Function deactivated
Si
Flashing light will be on during the pause time too
Strt
Activation inputs (START and START P.)
This menu allows selecting input operation modes (see chapter 5.4)
StAn StAn
StAn
Standard mode
no
Start inputs from terminal board are disabled.
Radio inputs operate in standard mode
StAn
APCh
Open/Close command
PrES
Dead man operation
oroL
Timer mode
StoP
Stop Input
no no
no
The input STOP is not available
ProS
The input STOP stops the gate: pressing the command START the gate
continues the motion
invE
The command STOP stops the gate: at the next START the gate starts
moving in the opposite direction
Fot1
Photocell 1 input
This menu allows enabling the input for type 1 photocells, that is to
say, photocells active both during the opening and closing phase
no no
no
Input disabled
APCh
Input enabled
Fot2
Photocell 2 input
This menu allows enabling the input for type 2 photocells, that is to
say, photocells non active during the opening phase
CFCh CFCh
CFCh
Input enabled even at standstill gate too
Ch
Input enabled for the closing phase only
m
WARNING: If the photocell is damaged the gate is opened
anyway.
Before closing the test of the photocell (if enabled) will detect
the fault and prevent the gate from closing.
no
Input disabled