V2 36A004, Руководство пользователя

Страница: 42 / 132

E
N
G
L
IS
H
40
6. Insert the cap D onto the boom
7. Mount bracket E on plate F , and screw in the 4 screws lightly
8. Insert the boom in bracket E until snug and screw in the
4 screws
9. Insert plastic cover G on bracket E
10. Apply the reflecting adhesive tape C (accessory code 163622)
on the sides of the boom
For the round boom follow the following indications
1. Cut boom A to the desired length
2. Insert stopper D on the boom
3. Mount bracket E on plate F , and screw in the 4 screws lightly
4. Insert the boom in bracket E until snug and screw in the
4 screws
For the flat boom follow the following indications
1. Cut boom A to the desired length
NOTE: if the lights kit is required (code 163615), the modules
have to be installed before mounting the rubber edge
2. Present the rubber anti-shock profile B on the bar before
inserting it and cut it to the desired length
NOTE:
the rubber profile must be 20 cm shorter than the bar length.
If the installation includes the fixed support (cod.163605),
shorten the rubber to prevent it from coming into contact with
the support.
3. Lubricate the rod and the rubber in the insertion area,
then proceed with the insertion
NOTE:
during insertion the rod experiences tensile stresses and
compressions that might alter its length.
DON'T shorten the rubber and proceed with the next points.
4. Knead the rubber with your hands to take up the extra
length caused by insertion.
5. Insert the two caps M onto the boom to seal the rubber
edge.
Drill the aluminium profile with a 2,5mm drill bit and screw
the caps with the supplied screw
BOOM INSTALLATION
If you are installing ZENIA6 with LEFT (SX) installation, before fitting the bar it is necessary to perform the following operations:
1. Stop the motor
2. Unscrew the 4 screws that affix plate F to the motor
3. Rotate the plate 90° and screw back in the four screws
NOTE: in order to ensure a lasting seal it is MANDATORY to use threading lock fluid
4. Unblock the motor and bring the plate back to the initial position