UTC Fire and Security Kidde AirSense SynaG Series, Руководство по установке

Страница: 57 / 104

Chapter 3: Configuration and commissioning
SynaG Series Installation Manual 51
3. Press Enter.
4. The software version is displayed in three consecutive segments, as shown
below.
Segment Description Example
Is the major release identifier
Is the minor release identifier
Is the version cycle number
In the above example, the reading is for software version 1.1.7.
Expansion board configuration
Adding an expansion board
Use this menu, available from the basic or advanced configuration menus, to
configure the number of installed expansion boards. The default value is 00.
To add an expansion board:
1. Set the display as shown below, and then press Enter.
The Expansion I/O Fault/Disabled LED flashes fast to indicate that the
module configuration menu is active.
2. Select a value using the value selection buttons (2 and 4).
3. Press Enter.
4. Save your changes.
The maximum number of expansion boards that can be installed is shown below.
Table 26: Maximum number of expansion boards
Two- and Four-zone control panels Up to two expansion boards
Eight-zone control panel Up to four expansion boards [1]
[1] Note: For regulatory compliance, when a fire network board is installed, make sure your
configuration does not exceed the usage of three expansion board modules.