UTAH SCIENTIFIC UTAH-100/UDS 10x10, Настройка и эксплуатация системы

Страница: 47 / 131

Section 2 2-11
Router Applet Activation and Configuration
Section 2
f. Click the Data Comm (radio button) to change the network configuration.
FIGURE 10.
Note: The program will display the router’s IP address (IP Address cell,
above). It is important however that Net mask and Gateway remain constant
among all devices, and to keep the DHCP box unchecked.
g. Enter the desired IP address in the space provided.
h. Verify the Port setting of 5001.
i. Make sure the DHCP box is unchecked.
j. Click the “Program Router” button when the network configuration is
complete.
k. A dialog will appear prompting you to reset the device. To make the IP
changes active, reset the router by pressing (and quickly releasing) the small
button at the far right side of the control module on the back of the router.
Note: There is no need to restart the browser when the router is reset.
Once the above steps are complete, the router can be placed on the target network and
configured as needed.