UTAH SCIENTIFIC UTAH-100/UDS 10x10, Настройка и эксплуатация системы

Страница: 49 / 131

Section 2 2-13
Panel Applet Activation and Configuration
Section 2
Since there is no router connected, click Cancel to dismiss this dialog.
The following window will appear, which will give you an opportunity to designate the
necessary configuration detail.
FIGURE 13.
The above illustration contains a default IP address (your address may be different).
The Controller IP corresponds to the router address, while the Panel IP and Gateway
are associated with the panel that you are using. Enter the correct addresses as
needed.
Click Configure Panel when the correct addresses are in place, then reset the
system.
A dialog will appear prompting you to reset the device. To make the IP changes
active, cycle the power to the panel or reset the panel by pressing (and quickly
releasing) the small button at the far right side of the control module (rear of panel).
Once the above steps are complete, the panel can be placed on the target network
and configured as needed.
You can now log in to the router and panel applets to configure you system as needed
using the newly configured IP addresses. The default username and password is
admin
, in both cases. Once you have logged in, click the configuration icons to
activate the configuration dialogs.
For additional assistance, please contact Utah Scientific Customer Service - 1(800)
447-7204.
Router
Panel