UTAH SCIENTIFIC UTAH-100/UDS 10x10, Настройка и эксплуатация системы

Страница: 110 / 131

A-4 RCP-1 Protocol for UDS
RCP1 Protocol for UDS
The controller will respond with a report consisting of a sequence of
status messages ordered by output number, with each message
formatted as follows:
STX OOOO <Matrix Input> <Matrix Output> <Checksum> CR
The report is terminated by the system controller with the ASCII Code US
(Hex 1F).
To obtain Status of a Single Matrix Output, the command string should be
terminated with a CR immediately following the starting matrix output
number:
ESC L <Start Output> CR
The controller will respond with a single status message formatted as
follows:
STX OOOO <Matrix Input> <Matrix Output> <Checksum> CR
Matrix Take Command
ASCII CODE HEX
Command Code: SOH 01
Response: None
Making a take.
Switcher cross points are changed by using the Matrix Take Command.
The Input Number and Output Number identify each cross point. (This
protocol supports levels, UDS does not support levels, any level set per
the level mapping as will make a take.). The command message is
structured as follows:
SOH <@@ | OO> <@@ | OO> <Matrix Input> <Matrix Output>
|<Checksum>| or |CR|
To generate a Matrix Take Command, issue the command SOH followed
by the code for enabled levels “OOOO” (note that this is the letter upper
case O) input and output selection and terminated by either the optional
checksum or carriage return (C/R). The following example, uses the
Matrix Take Command to select input 45 to output 123.
Symbol SOH O O 0 4 5 1 2 3 C/R
HEX 01 4F 4F 30,34,35 31,32,33 0D