URYU UBX-AF Series, Инструкция по эксплуатации

Страница: 17 / 26

3) Grip Switch to Activate the Built-in Controller Board.
4) Pull Trigger to operate the tool.
Before use, surely check if loosening of a screw, damage on tool’s appearance / battery contact part /
spare part is observed. Such factor may cause not only capacity deterioration or breakdown but also
danger.
See Pairing Manual for method of pairing the UBX-AF tool and UCC-100Z coordinator.
5. Attention For Operation
5.1 Factors Affecting Fastening Torque
1) Fastening torque can change even for the same sized bolt because of torque coefficient determined by
finishing status of fastener or workpiece such as industrial quality ranking of the fastener and / or its
length. Fastening torque can also change by the surface condition of workpiece or each condition of
workpieces. Great torque drop can be seen when the bolt and nut rotate simultaneously.
2) A wobbling socket loses torque transmission a lot, makes vibration bigger and gives burden onto the tool
or the operator. Also, an unnecessary big or heavy socket causes torque scatter. Use an appropriate size
of socket for the bolt. As extension bar / guided socket is recommended to minimise torque-down and
wobbling.
3) Pull the trigger firmly to operate the tool. If the trigger is not pulled correctly, the tool may not be stopped
automatically.
4) Torque-drop can be seen when a universal joint or socket connector is used.
5.2 General Instructions For Use
1) Decide the rotation direction by the Fwd/Rev lever.
2) Pull the trigger.
-1. Speed increases in 3 steps as you pull the trigger
progressively for both forward and reverse.
-2. If you release your finger from the trigger, an electric brake automatically engages to stop anvil rotation.
3) Fastening
Keep pulling the trigger until automatic shut-off.
- Fastening torque does not reach preset torque if you release the trigger prior to automatic shut-off.
When torque reaches preset torque, the tool stops automatically.
(Green LED and OK buzzer Confirm OK tightening).
15
Battery power indication LED
and ZigBee Communication
LED (Green) turns ON.
After tightening job is completed, the green ZigBee communication LED turns off, which disables the
tool. Only after the tool has received a tightening parameter setting from some upper device, via ZigBee,
the ZigBee communication LED turns on again, which enables the tool to start tightening operation in
accordance to the newly received parameter setting.
Forward
Reverse
Fwd/Rev Lever
Lever
Trigger