04. Precautions in using the product
Warning. Not following the instructions can lead to serious injuries or death.
Caution. Not following the instructions can lead to minor Injuries or damage to the products.
If the Product is wet, do not place it in the heater or in the
microwave oven to dry.
It may cause explosion, deformation or product failure
which is not covered under the warranty.
Do not alter or impact on the Product.
Unauthorized alteration or product damage by impact shall
not be covered under the warranty..
Do not use chemicals (such as benzene, thinner,
alcohol) or detergent to clean the Product.
It may cause fire..
Do not install or operate the Product while driving.
Operation of the Product while driving can cause accidents.
Pull over to a safe spot to operate the Product..
This Section is for your safety and proper use of the Product to prevent safety accidents/risks. The manufacturer shall not
be responsible for troubles caused by use of the Product in violation of the instructions.
If the Product is directly connected to the car, do not use
the product for an extensive period of time.
It may discharge the battery.
Make sure that the double-side adhesive tape is firmly
affixed during installation.
The Product may show poor performance by over time
moving or motor vibration.
Install the Product in unaffected area by the Navigation or
HIPASS device.
Reflections of images of Navigation or HIPASS may cause
poor recording quality.
Keep the windshield clean.
Foreign materials may prevent normal recording of images..
Back up files periodically.
When the SD Card is full, the oldest file in the Card will be
overwritten by a new file. Please back up data periodically to
prevent unwanted data loss.
Please do not use sharp devices on the LCD.
The touch panel or LCD may be damaged by sharp devices
when the black box is set up with them on the LCD.
Avoid an area where the product is exposed to direct sunlight
when parked.
If used for long hours in an air-tight environment inside a car
and in direct sunlight, the product may malfunction.
Watch out for using memory cards and removing it.
Uncertified Micro SD card may not be recorded properly.
Please remove the power cable before inserting or removing
the SD Card
6
Содержание Albatross II MD-7500P
Страница 11: ...08 Part names and functions front camera 11 11...