Uponor SETPOINT 511S, Инструкция по установке и эксплуатации

Страница: 4 / 16

Section 2
Installation
Getting Ready
Check the contents of this package. If any contents listed below are
missing or damaged, please contact your Uponor sales representative
or distributor for assistance.
• SetPoint 511s (part number A3041511) includes one programmable
SetPoint Controller, one Floor Sensor (part number A3040079), an
Installation and Operation Manual and a User Manual.
• SetPoint 512 (part number A3040512) includes one programmabale
SetPoint Controller, an Installation and Operation Manual and a
User Manual.
Removing the Front Cover
1. Place a screwdriver or similar object into the
small slot located in the top of the controller.
2. Push the screwdriver against the plastic tab
and pull the top of the front cover so that it
pivots around the bottom edge of the base.
(See Figure 1 .)
Mounting the Base
1. Install the controller on an interior wall of
the desired zone approximately 5 feet (1.5m)
above the floor.
Note: Do not mount the controller in a
location that may be affected by
localized heat sources or cold drafts.
2. If necessary, install a draft barrier behind
the controller to prevent air from blowing
through the wiring hole and affecting the
controller’s built-in sensor.
3. Mount the base directly to the wall using
two #6 1-inch screws. (See Figure 2 .)
3 2
Section 2 — Installation
.
.
#6 1" screws
Figure 1:
Removing the Front Cover
Figure 2:
Mounting the Base