© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
7
CAUTION:
Read all instructions before assembly. Failure to assemble properly may result in
damage or personal injury.
WARNING:
Keep hands clear of the column while it is rising and falling. Do not touch it.
CAUTION:
Only plug into 120Vac outlets. (Input: 120Vac, 60Hz, 200W max)
CAUTION:
The maximum load capacity of the unit is 110 lbs. Do not overload.
CAUTION:
Keep devices centered and away from the edge of the main worksurface,
to prevent them from falling.
CAUTION:
Make sure that the wires for your monitor and devices have enough slack to prevent
your devices from being pulled off the unit workstation when raising the unit.
CAUTION:
When relocating the unit, remove all devices to avoid harm or damage,
and adjust the unit to its lowest position.
CAUTION:
When relocating the unit, move it carefully with two people, to avoid injury and
damage to the product and surroundings.
CAUTIONS & WARNINGS
!
!
!
!
!
!
!
!
!
If the error message persists after performing the Reset procedure, contact UPLIFT Desk at the email ad-
dress or phone numbers listed at the bottom of each page of these instructions.
CODE
DESCRIPTION
TROUBLESHOOTING SOLUTION
H01
Overheated
The desk motor has a 10% duty cycle to protect from overheating. For
example, in a 20 minute period if your desk motor is activated for 2 minutes
you will want to let it rest for 18 minutes. Otherwise you may see an H01
code on your keypad.”
E01
Firmware or
connectivity issues
Check all cables to ensure they’re all firmly plugged in, and perform Reset
procedure above.
E07
Hall sensor error
Perform Reset procedure described previously.
TROUBLESHOOTING (continued)
