© UPLIFT Desk
• 800-349-3839 • 512-614-3152 • [email protected] • upliftdesk.com
6
Note:
If memory settings were previously set outside of the new minimum and maximum height
settings, they will default to the new minimum and maximum settings. To set new minimum and
maximum height settings outside of the current settings, you will need to first remove the current
minimum and maximum settings.
DISPLAY UNITS
Change the numeric display to show heights in either inches or centimeters.
l. Press the DOWN button until the unit reaches the lowest position. Release button.
2. Press the DOWN button until display flashes “RST”.
3. Press the “2” button until display shows “10.3” (centimeters) or “10.4” (inches) and goes
back to “RST”.
Note:
While “RST” is still flashing, you can press the “2” button as many times as you’d like
to toggle between the two settings.
4. Press the DOWN button until the unit lowers slightly, then rises slightly and the display
changes back to the numeric height setting.
PROGRAMMING (continued)
To set a new maximum desk height:
l. Use the UP or DOWN button to bring the desk to the desired
maximum
height.
2. Press the “M” button once, and “S-” will appear on the Display. Immediately follow by
pressing the UP button once, so the “S-” flashes once.
3. Hold the “M” button until the Display shows “999” then changes to numeric value of new
upper limit.
To set a new minimum desk height:
l. Use the UP or DOWN buttons to bring the desk to the desired
minimum
height.
2. Press the “M” button once, and “S-” will appear on the Display. Immediately follow by
pressing the DOWN button once, so the “S-” flashes once.
3. Hold the “M” button until the Display shows “000” then changes to numeric value of new
lower limit.
Removing adjusted maximum and minimum heights:
l. Press the “M” button once and the display will show “S-”.
2. Hold the “M” button again until the display shows “555” then changes to the current
numeric height setting.
MINIMUM & MAXIMUM HEIGHT SETTINGS
The unit ships defaulted to its minimum and maximum height limits. These steps allow the upper
and lower limits to be adjusted to your preference.
If your converter does not respond when you try to raise it or lower it, or if the Keypad displays error mes-
sages (“EO1” or “EO7”), check to make sure all the cables are secure (Lifting column to cable, cable to Con-
trol box). If the problem persists, perform the reset procedure below.
*Note:
“RST” will look like
“ASr” on the display
RESET PROCEDURE
1. Unplug the power cord and hold the DOWN button on the Keypad for 30 seconds.
2. Plug the power cord back in.
3. Hold the DOWN button until the Lifting column reaches its lowest height, then release.
Hold the DOWN button again until the LED display reads “RST”
(or for about 10 seconds on non-LED keypads), then release.
Hold the DOWN button again until the Lifting column lowers a
bit more, then slightly rises and stops, then release. Your desk is
now ready to use.
4.
The Advanced Keypad will should display the current height, and the unit should be operational.
5. You may also need to do this if the unit is ever unplugged or loses power.
TROUBLESHOOTING
