P a g e
| 22
ÜKY/DUO Boiler User Manual
Find the
Fuel Feed and
Fuel Waiting settings in
the "Fuel Waiting - Feed Settings" section of your manual, according
to the boiler capacity and fuel type.
Press the Fuel Feed button to set the amount of
fuel to be fed into the boiler. Press the ENTER button after setting
the power supply setting.
Press the Fuel Waiting button for the standby setting. Press the
ENTER button after setting the standby setting.
Set some materials to easily ignite and then ignite the boiler.
Later
Close the boiler doors and press the
Fan On / Off button
on the panel. The Fan lamp on the upper right side of the control
panel will illuminate and HEAT will appear on the display.
If the ignition aids in the boiler ignite the fuel, press the
Reducer On / Off button to switch on the gear unit. The on / off
button on the gear unit will light up. The gearbox lamp in the upper
right corner of the control panel will only be activated when the gear
unit is running.
The countdown timer at the right-hand corner of the display counts
down from the minute value set for standby to seconds in which the
text WAIT is displayed.
Overheating of the fan speed will cause some heat to be discharged from the chimney. In the
case of combustion, one to one and a large amount of air will cause adhesion to the slag. It can
be played with feed and standby settings to prevent the unburned fuel from falling off the pot.
