P a g e
| 21
ÜKY/DUO Boiler User Manual
STARTING UP
The following steps should be followed for the initial start of the boiler:
Check the installation for any obvious defects. If there is a fault,
remove information from the ”Information on Usage Errors İlişkin
page.
In closed systems, observe that the water is not removed from the
manometer and the hydrometer in open systems. Add water if it is
minimized.
Check the power line of the boiler for any obvious defects. If there is
a fault, look at information from the Information on Usage Errors
page.
Fill the hopper with fuel and close the cap tightly.
Open the control panel by pressing the button
for 2
seconds. When turned on, the blue graph will display values next to
the Feed, Set Temperature, Standby variables.
Since the buttons
and
, HEATING is not seen
because the buttons are not pressed and the boiler does not work.
Open the boiler lower cover and hold the finger
on the
Manual Fuel Feed button on the control panel to allow the fuel to fill
into the crucible, into the holes.
When pressing the button, you will see the Reducer light in the
upper right corner of the panel illuminate.
It is useful to set the boiler water temperature to 60°C at the first
start.
To do so, press the
Temperature Adjustment button on
the panel. The display shows TEMPERATURE SET. You can press and
hold the
buttons until the desired temperature is
set.
You can store them by pressing the
ENTER button.
Press the
Fan Setting button of the panel. A rectangle will
appear around the line in the upper left corner.
press the button once to increase the fan stage once again
and the second shape.
When you press the
ENTER button, the setting of the fan you
have set will be memorized and the display will be as in the third
figure.
