Unitek Peco PHASEMASTER 6, Руководство пользователя

Страница: 54 / 69

CHAPTER 4: MAINTENANCE
PHASEMASTER™ 6 DIRECT ENERGY WELDING CONTROL
4-4 990-083
Press any arrow key to exit the Calibration Screen and enter the RUN State.
Memory Initialization
The following procedure re-sets all Schedules in memory to default values:
•
With the power OFF, select [NO WELD]
•
Press both [SAVE] and [PROGRAM]
•
Hold both keys down while the power is turned ON
•
Do not release the keys until the self-test display is shown. See Calibration Check.
Each Schedule should be displayed in sequence, starting from 0, showing the new default values as
follows:
0
+
0
.5
0
2
0
After displaying Schedule 7, the PM6 will automatically enter the Run State.
Repair Service
Telephone Service
Call our Repair Department at the telephone number shown in the Foreword of this manual. Before
calling, please obtain the model number and serial number from the identification plate on the rear
panel.
Factory Service Repair
We provide a repair service for both warranty and non-warranty repairs. Call our Customer Service
Department at the telephone number shown in the Foreword of this manual for a Return Material
Authorization number. All equipment to be returned to us for repair must be shipped PREPAID.
Please include information concerning the type of problem you are experiencing. Include with the
shipping information the name and telephone number of the person whom we should call with the
estimated cost of repairs.