United States Stove Company Hot Blast HB1520, Инструкция и руководство по эксплуатации для владельца

Страница: 18 / 52

18
© 2023 United States Stove Company
MAIN FIREWOOD LOAD
• Ensure that the combustion fan is ON, and open the
feed door to insert the main firewood load.
• After loading, leave the feed door slightly open for five
minutes (5 min) to ensure proper ignition, then close
the door.
• The damper on the combustion fan should be open.
• Depending on the temperature at which the wall
thermostat is set, this will determine the burn duration
of the main load. A lower setting on the thermostat
should result in a longer burn time as this would allow
the combustion fan to remain OFF for longer periods.
A higher thermostat setting will cycle the combustion
blower ON/OFF more often, resulting in a hotter, but
shorter duration burn time of course. However, colder
outside temperatures and your home’s construction
(insulation) will play a big factor in how well the
thermostat can maintain it’s set temperature.
VISIBLE SMOKE
The amount of visible smoke being produced can be
an effective method of determining how efficiently the
combustion process is taking place at the given settings.
Visible smoke consist of unburned fuel and moisture
leaving your stove. Learn to adjust the air settings of your
specific unit to produce the smallest amount of visible
smoke. Wood that has not been seasoned properly and
has a high wood moisture content will produce excess
visible smoke and burn poorly. Use the included moisture
meter to ensure your wood has a 20% or less moisture
content.
AIR TUBES
The air tubes assembled in this unit are designed to
provide an accurate mix of secondary air to ensure the
highest efficiency. Any damage or deterioration of these
tubes may reduce the efficiency of combustion. The air
tubes are held in position by screws or snap pins. Locate
these to either side of the tube and remove it to allow the
tube to be removed and replaced.
OPERATION