- 113 -
MS926 User’s Manual
■
Check for non-numeric character
ED
Check to make sure there is a non-numeric ASCII character at the
current cursor position. The format is aborted if the character is numeric.
ED Example: Only output the data if the bar code begins with a letter
If you want only data from bar codes that begin with a letter, you can use ED to
check for the letter.
Command string:
EDF10D
ED is the “Check for a non-numeric character” command
F1 is the “Send all characters” command
0D is the hex value for a CR
If this bar code is read:
the next data format, if there is one, will
be used on this data. If there is no other format, the format fails and the raw
data is output as
1234AB.
If this bar code is read:
the data is
output as:
AB1234 <CR>
■
Insert a delay
EF
Inserts a delay of up to 49,995 milliseconds (in multiples of 5), starting
from the current cursor position. Syntax = EFnnnn where nnnn stands for
the delay in 5ms increments, up to 9999. This command can only be
used with keyboard emulation.a
■
Discard Data
B8
Discards types of data. For example, you may want to discard Code 128
bar codes that begin with the letter A. In step 4 , select 6A (for Code 128),
and in step 5, select 9999 (for all lengths). Enter FE41B8 to compare
and discard Code 128 bar codes that begin with the letter A. Syntax =
B8.
Note: The B8 command must be entered after all other commands. The Data Format must
be Required in order for the B8 command to work. If Data Format is On, but Not
Required,, bar code data that meets the B8 format is scanned and output as usual.
Because the data format needs to be On and Required for the B8 command, you
must input data formats for all bar codes you wish to discard as well as all bar
codes you wish to output. Other data format settings impact the B8 command. If
Data Format Non-Match Error Tone is On , the scan engine emits an error tone. If
Содержание MS962
