Unipulse F701-P, Руководство по эксплуатации

Страница: 6 / 116

Notice at the Time of Unpacking or Re-packing
V
Notice at the Time of Unpacking or Re-packing
V
Notice at the Time of Unpacking or Re-packing
Please be careful following matters when you unpack the carton containing our product.
●
Unpack the carton in the clean space to prevent troubles caused by dust or dirt.
●
Check the product visually whether there is any crack or damage on the external
appearance after unpacking.
●
Check the attachments and confirm the number of them.
1. The attachments are packed in the carton box with the product.
Take out the product holder and the attachments from the individual box.
Then take the product out of the product holder as shown in the figures below.
* The durability of product holder is not enough for the use of repetition. Reuse of the product holder is
not recommended. In case you have to use it for re-packing, Please confirm the deterioration of the
film and cardboard then follow procedure below. Depending on deterioration of the film, We
recommend to pack with additional cushioning material or pack with new cushioning material.
2. When you re-pack the product please follow the guidance of figures below.
If you find any damage on the product or lack of contents, please contact the department of Unipulse or
our agency where you purchased the product with having kept the state as it is.
①
Take the product holder,
attachment case and
operation manual out
of the individual box.
Attachments are
contained in the
attachment case.
②
Take the product out of the
product holder.
Return the each part of
bent cardboard downward.
③
Then return the lower part
of card board in the 90
degrees direction of
②
to
ease the tension of film.
④
Take out the product
between the cardboard
and film.
①
Insert the product
between the center
of the film and the
card board of the
product holder.
②
Then bend the each
part of cardboard
downward to the
direction of stretching
the film as shown in
the figure.
③
Bent the each part of
cardboard in the 90
degrees direction of
②
upward as shown
in the figure.
④
Bend fold line inside
of fold line made by
③
to downward as
shown in the figure
so as to narrow width
of the product folder.
⑤
Place cushioning
material in a bottom
of the individual box
then put attachment
and operation
manual into the
individual box as
shown in the figure.