Unipulse F701-P, Руководство по эксплуатации

Страница: 4 / 116

CAUTION
III
CAUTION
III
CAUTION
●
Use the F701-P as it is incorporated in a control panel, etc.
●
Do not install in the following environments.
- Where the temperature/humidity exceeds the range of the specifications.
- Where the temperature changes remarkably or there is a danger of freezing or condensing.
- Outdoors, or where the altitude exceeds 2000m.
- Places exposed to direct sunlight.
- Dusty places.
- Locations with poor ventilation.
- Places containing large quantities of salt or iron powder.
- Where the main body is directly affected by vibrations or shocks.
●
Take adequate shielding measures when using at the following locations.
- Near a power line.
- Where a strong electric field or magnetic field is formed.
- Where static electricity, relay noise or the like is generated.
●
Install the F701-P as far away from devices generating high frequency, high voltage, large
current, surge, etc., as possible. Also, carry out wiring separately from their power lines. Do
not carry out parallel wiring and common wiring.
●
Do not use it, broken down.
●
Tighten the screws for the terminals at the specified torque.
If they are loose, shorts, fire or malfunctions may occur.
Tightening torque: 0.5 N• m
●
For sensors, external inputs/outputs and RS-485, use shielded cables.
●
The temporary overvoltage applied to the power should not exceed 1500V.
●
For turning on/off the power, be sure to keep intervals of 5 seconds or more.
●
After power-on, make sure to warm up the F701-P for at least 30 minutes or more before use.
●
If the F701-P is not used by the specified method, its protective performance may be
impaired.
●
Maintenance
- When performing maintenance, disconnect the power.
- Do not wipe with a wet rag, or with benzine, thinner, alcohol, etc. Doing so may cause
discoloration or deformation of the F701-P. In the case of heavy contamination, wipe off
the contamination with a cloth after dipping it into a diluted neutral detergent and wringing
it well, and then wipe with a soft, dry cloth.
This sign forewarns the presence of hazards
that could result in personnel injury or property
damage when incorrectly handled.
Caution on installation
Caution on wiring
Caution during startup and maintenance