Unipro UniGo 5005, Руководство пользователя

Страница: 15 / 56

15
MAGNET RECEIVER
The magnet receiver uses permanently
magnets placed in the asphalt to trigger the
Laptimer. There is typically between 1 and 3
magnets on a track. If there are more than
one, the rest is used for split points.
Magnet receiver mounted at the lowest
point on the go-kart.
The magnet receiver need to be mounted as
close to the asphalt as possible, typically on
the bottom plate at the front. Use the included
bracket and drill a hole in the plate. The
receiver need to be facing either against the
front or the rear. Do not mount it facing left
or right.
IR RECEIVER
The IR receiver use infrared light to trigger the
Laptimer. A Unipro IR transmitter is placed at
the start/finish line and the infrared light goes
across the track. The infrared receiver placed
on the kart will receive the infrared beam and
trigger the Laptimer.
IR receiver mounter at the front, facing the
right way at the start/finish line!
The IR receiver is installed on the front of the
kart. It should be pointing to the left or right
depending on the placement of the transmit-
ter.
SPEED KIT FRONT
The speed kit for the front wheel is used if the
kart do not use brakes at the front wheels.
Start by mounting the centering bush the
bearing. This will be used to ensure a perfect
centered sensor disc.
The centering bush is placed in the bearing.
Sensor disc is fixed using the three screws
and centered using the centering bush.
Then place the sensor disc and fasten the three
screws. Make sure to tighten them equally.
I n s t a l l i n g t h e
L a p t i m e r
Installation