Unipro UniGo 5005, Руководство пользователя

Страница: 30 / 56

30
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
and revert to the original value.
USE TIMER NUMBER
UniGo have five engine timers, but only one of
them is active at a time. You can use one timer
for each of your engines to keep track of the
number of hours used. Remember to change
the timer number when changing engine.
TIMER no MENU
The timer number 1 - 5 menu contains each of
the engine timers.
Engine number 3 is used for 5 hours and
26 minutes.
Here you can see the timer value, manually
adjust it and reset it.
TIMER no
The line with the engine timer is used to see
the timer value and manually adjust it. If you
forget to change the engine timer number
when changing the engine, you can add the
time to the correct timer manually.
RESET COUNTER
If the engine is rebuild or a new engine is
used, you can reset the engine timer here.
Change the value to Yes and press the
ok
button ( ).
STROKE
The engine stroke is typically only set once.
Adjust it to the stroke of the engine. It can be
set between 1- and 6-stroke. Please notice that
some engines works differently than expected,
so if you see the RPM showing incorrected
values, try to adjust the stroke setting.
RPM SHIFT
When using gears the RPM shift setting is im-
portant. The gear shift indicator is depending
on two settings. The RPM shift value and the
RPM delta value. The RPM shift value is set to
the engine revolution you want to shift gear at.
If you want to shift at 12500 RPM, you need to
set this value at 12500.
All five LEDs are used for gear shift indicator,
but they have higher priority than normal LED
warnings. This means, that even if the warning
LEDs might be turned on or are blinking, the
shift lift overrules this and turn all the LEDs
into a shift light indicator when needed.
RPM DELTA
The RPM delta value is the “distance” between
the LEDs when used as a shift light indicator.
If you for example want to shift at 12500 RPM
and set the RPM delta value to 300, the shift
light will turn on at 11900, 12200, 12500,
12800 and 13100 RPM. The smaller delta
value, the faster reacts the shift light.
RPM SHIFT TYPE
The RPM shift lights always blinks in a flashy
way, but with this setting you can select if the
indicator uses the LEDs as single LEDs or all
at once. If set to all at once, all LEDs will flash
when the RPM shift point is reached and the
RPM delta value will not be used.
RPM BARGRAPH MAX
When using the RPM bargraph on the run
mode 2 screen, you need to set the maximum
RPM value that could be shown. The bargraph
covers from 0 to 10000 RPMs. If you set the
maximum value to 13000, the RPM bargraph
will show values from 3000 to 13000 RPMs.