UNIPRO – The original Laptimer
55
Trouble Shooting
Here are the answers to som frequently asked questions. If you have any problems or questions
regarding your Unipro Laptimer we will make sure to give you the necessary support.
Please e-mail your questions to
or contact your local dealer.
The Laptimer is turned on, but do not register the lap time
•
Is the IR/Loop transmitter turned on?
•
Is the IR/Loop receiver placed horizontal and in the right height?
•
Is the receiver connecter tightened?
•
Did you choose the right receiver type in setup mode?
•
Is the magnet receiver placed lengthwise?
•
Is the distance between the IR transmitter and receiver correct (> 2 meters)
•
Do the Laptimer not receive a signal every time the transmitter/Loop is passed? Then
check to see if the delay time is set to high. You need to set this a little below the fastest
lap time.
The Laptimer does not measure correct speed/split
•
Check if the distance between the wheel sensor and the sensor disc is correct (3 – 10
mm)?
•
Are all six magnets still in the sensor disc?
The PC is reporting a none standard USB device plugged in!
•
This is typical a problem because you did not plug the USB cable into the right connector
on the Laptimer! Typical you did insert it into the AUX connector or RECV 2 connector
instead!
The RPM value is excessively high!
•
Check the stroke settings in setup mode. Perhaps you adjusted it down to 1-stroke?
