UNIPRO – The original Laptimer
32
Laptimer setup
This will show you all the functions in setup mode. You get to setup mode by pressing
after
you have turned on the Laptimer. You go from one setup to the next by pressing
again.
When you get to the last setup, it will start again from the start when pressing
Please note: All changes you make in setup mode is saved as soon as you have made the
change. Just press the
button to leave setup mode. It is made this easy because there are
some settings you need to change every time you start a new run – training or race.
Engine timers
The Laptimer can store the run time of up to 25 different
engines, each running up to 999 hours and 59 minutes.
Before every training or race, you simply go to setup mode
and choose the engine you are using, by using the
and
buttons to find the right engine number.
If you should forget to choose the right engine timer before a training or a race, you can
manually edit the timers. First, choose the right engine timer and then push
. This will
give you access to edit the minutes registered on the chosen engine timer. This is explained in
the next step.
You can use the
and
buttons to change minutes
registered on the chosen engine timer. Each press will count
one minute up or down. You can press
to reset the
timer. Close engine time edit by pressing
.
