UNIPRO – The original Laptimer
22
Installation
Your Laptimer is a precision instrument and you should take the necessary time to ensure correct
installation. A basic rule is to start from the sensors and go back to the Laptimer, never the other
way. If cables are too long, they should always be looped at the end near the Laptimer. Use
plenty of strips to fix the cables to the frame.
DISPLAY UNIT
The Display Unit is mounted on the steering wheel. Due to the ultra thin Display Unit, you will not
have any problems with regulations.
First, the Display Unit is mounted on the steering
wheel. Choose a hole that gives a good placement at the
top of the steering wheel. On some steering wheels, it is
necessary to make the hole a little bigger.
Remove the nut, the gray washer and one of the two
black rubber washers. These parts are mounted on the
back side of the steering wheel, as shown in figure 1.
It is important to keep the right order of the washers.
Please follow this sequence:
Nut – metal washer – gray plastic washer – black rubber
washer – steering wheel – black rubber washer – Display
Unit.
Tighten the nut when the display is strait and centered in the
steering wheel. This picture shows the correct mounted
Display Unit.
MAIN BOX
The main box is mounted behind the front cover. The following picture is showing the main box
and its components.
Rubber washer
Steering wheel
Rubber washer
Display unit
Gray washer
Metal washer
Nut
