UniPOS VIT 01, Инструкция по эксплуатации

Страница: 33 / 51

UniPOS Wireless Fire Alarm Control Panel VIT 01
Instruction manual Page 33
Revision 10/02.17 Pages 51

Adding new devices in the system;

Removing devices (switching off);

Replacing an old device with a new one;

Changing the mode of operation of the devices;

Disable and enable devices;

Changing parameters of the devices.
12.4.3.1. Registration is devided into 2 basic submenus
– automatic and manual.
Upon the automatic registration, each newly registered device is assigned with a following serial
number (address) and it is automatically included within the system.
Upon the manual registration, the newly registered device can be added, to replace the
previously switched off device, or not to be included in the system.
All other functions for setting parameters and changing the modes of the devices are identical.
The choice between automatic and manual
registration shall be done immediately after
entering the menu.
The main window of both types is identical:
On the first line are described the type of
registration and the idenetical code of the radio
network.
On the second
–channel andthe identical
code of the last registered device into the
system .
On the third
– the total network status and
the mode of connection of the Control Panel.
The last line shows the total number of
registered devices, those one connected directly
to the Control Panel, and the active devices in
the network.
If there are any disturbances of the normal operation of the system, the field "Status" displays
one of the following indexes:

N
– there is a registered device,which is not in the network (not responding);

T
– there is a device which is removed from its base;

B
– there is a device with a low battery;

D
– there is a contaminated optical-smoke or a combined detector;

E
– there is a detector with a low back up battery;

F
– there is a fire detector in Fire condition.
Press button
„Menu” to open the
window for selecting:

Enable/Disable connection of devices
directly to the Control Panel in the
network configuration of the system;

Clear network configuration
– this
option will send command to all