PRINT AND CUT ALIGNMENT
The Y adjustment next to the preview allows you to set
the vertical position of the cut line
By increasing the Y you move the cutting upwards.
By decreasing the Y you move the cutting downwards.
The X adjustment allows you to set up the horizontal
position of the cut line
By increasing the X you move the cutting rightwards.
By decreasing the X you move the cutting leftwards.
The change of position is in tenths of a millimeter.
The
adjustment is necessary the
fi
rst time you install the
cutter.
When you press the “
Start
” button the values are
memorized and the following adjustments start from
a “zero” value.
Small variation can be inserted also during the
processing; every variation will be eective from the
next sheet.
i.e. In case your plotting job is
0.5mm lower than your desired cut
job, enter 5 on the Y box to move it
higher.
The “
Calibration
” button allow a cut-peel-measure procedure to
fi
nd the proper
alignment between printed graphics and cut path. You have to insert manually one
of the black adhesive sheets provided.
Lower the media lever, insert manually the sheet , rise the lever and press the key
#2
on
the panel.
If the black adhesive sheets for the calibration procedure were not available you can print the
fi
le caliblack.pdf available
among the sample
fi
les.
The sheet must be in a central position
between the push rollers.
You can align it with the edge of the
feeder to keep it straight.
