It is strongly recommended to use the “
Cut test
” button before the automatic execution of
the work.
You may check the cut alignment and the cutting force.
Since the blades is consumed gradually during the work, you have to set a cut force for a
neat cut of the adhesive media.
You should verify that the label peel
t
o perfectly and that the blade ha
s just
slightly
pressed on
the liner.
When you are cutting hundreds or thousands of sheets, remember check the cut quality
when you put a new load of sheets on the feeder.
When the blade is new the cut force setting for an adhesive media may vary from 6 to 9.
If you set a force higher than 14 you get an message warning when you press “
Cut test
”
or “
Start
” : Cut force too high - Continue ?
It is an informative message, you can press “
OK
” to continue.
If you are using a standard adhesive media, when you exceed a cut force of 14, it is time
to replace the blade or at least to check if you have a spare one to replace soon.
