Unical INOXIA GJ Series, Руководство по установке и обслуживанию

Страница: 50 / 56

50
Instructions for the installer
The instruments panels of the boilers INOXIA GJ (cascade)
manage automatically the turn off the burner when the
temperature in the boiler reaches the value set on the
controller.
It also runs the pump for the load of a for the heater
production of A.C.S.
The management of heating, it comes automatically on
the basis of data collected by the sensors external boiler
environment and delivery
The high temperature zone pump system will be in a position
of working through the control switch pos.20 of the Master
table, and will turn off only when reaches the temperature by
the thermo regulator.
The pump system lower temperature zone, is put on operating
status through the control switch pos. 21 of the Master table,
and will turn off only when reaches the temperature delivery
through the thermo regulator
.
The charge pump of the boiler for the production of acs,
will be put into operation automatically, and will be switched
off when will reach the temperature of delivery through the
controller.
The panel is designed for the management of burners in
operation modulator.
For practical connections, electrical, and probes, refer to the diagram supplied with the panel
instruments cod. 38778 and 37901
With this plant configuration, the controller is able to control:
- Plant of a direct area, the controller controls the pump plant.
The temperature will be controlled by programming curves set
in the thermo regulator
.
- Plant of an area with motorized mixing valve: install the flow
sensor (downstream of the valve
mixing), the controller controls the pump system and
mixing valve. The temperature will be adjusted
through curves programming set in the thermo regulator;
- Production of a.c.s. through boiler;
- Anti-Legionella function with increased water temperature
storage in the boiler (function not enabled
factory, but which can be activated by the
customer)