Ulvac DC-5-P, Руководство по эксплуатации

Страница: 24 / 105

DC Pulse Power Supply
【
DC-5-P/DC-10-P
】 3 PREPARATION
12
Table 2-7. HARTING connector pin assignment at the cable side of input section(DC-5-P)
Connector Pin Number Connection destination
1 L1(R phase)
2 L2(S phase)
3 L3(T phase)
Ground GND
Table 2-8. HARTING connector pin assignment at the cable side of input section(DC-10-P)
Connector Pin Number Connection destination
A L1(R phase)
B L2(S phase)
C L3(T phase)
frame GND
2-5-2. Connection of output section
As with the input section, a [HARTING] connector is employed also in the output section.
Although the genuine cable can be purchased from us, if you prepare a cable by yourself, purchase
connector component parts with reference to the items of [Table 2-9. HARTING connector
configuration at the cable side of output section], select a suitable wiring material, and complete the
installation.
A special tool is required. Contact the manufacturer for the details of installation conditions etc.
When selecting a wiring material used for the cable, refer to [Table 2-2. Electrical specification], and
select the one that would satisfy the rating specification.
In addition, select a suitable cable ground based on the line shape of the wiring material selected.
Figure 2-3. Assignment of output connector at the product side(Common to DC-5-P and DC-10-P)
Table 2-9. HARTING connector configuration at the cable side of output section
Name Model Q’ty
Han 70A crimp module,male 09 14 002 3041 1
Carrier hood 09 14 001 0311 1
Hood Top Entry M25 72 14 001 0401 1
70A contact,male 6mm 2 09 11 000 6130 1
70A contact,male 4mm
2
09 11 000 6137 1
Table 2-10. HARTING connector pin assignment at the cable side of output section
Connector Pin Number Connection destination
1 Cathode
2 Anode
It is recommended to use our cable for I/O cables.
We shall not take any responsibility on malfunctions and defects as a result of
using a cable which is prepared by the customers. Please acknowledge
beforehand.
CAUTION