ultracomfort Power Recline UC551-L, Руководство по обслуживанию

Страница: 9 / 94

9
Replacement Instructions
Smart Tek ® Hand Control Replacement
Tools Needed: None
1. Unplug the transformer from the wall outlet.
2. Reach down into the pocket until you feel the disconnect latch
on the extension cable.
3. Pull back on the disconnect latch.
4. Put one hand on the back of the extension wire plug base and
one on the hand control plug base and pull the two pieces apart.
5. Plug in the new Smart Tek® hand control to the extension cable.
6. Push forward on the disconnect latch. Make sure it engages
fully with the hand control plug base.
7. Plug the transformer into the wall outlet and test the hand
control.
Hand Control Extension Replacement
Tools Needed: Phillips head screwdriver, wire cutter,
staple remover, stapler, zip ties, and a chair stand.
1. Unplug the transformer from the wall outlet.
2. Reach down into the chair’s side pocket until you feel the
disconnect latch on the hand control extension.
3. Pull back on the disconnecting latch.
4. Put one hand on the back of the extension wire plug base and
one on the hand control plug base and pull the two pieces apart.
5. Gently push the chair over onto the footrest, turn it upside down
or, gently push it over onto its side, opposite of the hand control.
6. Use a Phillips screwdriver to remove the wire clamp used to
secure the extension cable to the bottom of the armrests. Make sure you save the clamp and
screw.
7. Remove a few staples on the arm assembly to allow the extension wire to be pulled out through
the fabric pocket.
8. Pull the extension cable through the fabric pocket.
9. Locate the zip ties that hold the extension wire to the lift frame. Note their location.
10. Cut these ties.
11. Unplug the extension cable from the motor or control box on the 500 lb. chair.
12. Plug the new extension cable into the motor or control box on the 500 lb. chair.
13. Secure it to the lift frame with zip ties. Use the same locations as the old extension cable.
14. Insert the extension cable into the fabric pocket.
15. Reinstall the staples that were removed in step 8.
16. Reinstall the wire clamp.
17. Turn the chair back over onto its legs.
18. Plug in the Smart Tek® hand control to the extension cable.
19. Push forward on the disconnecting latch. Make sure it engages fully with the hand control plug
base.
20. Clip the Smart Tek® hand control to the black plastic hook on the side of the chair arm.
21. Plug the transformer back into the wall outlet and test.