www.ultraoptics.com
page 18
cup as a vertical strip as shown in Figure 7.
a. This reflective tape is supplied with the tachometer if acquired from Ultra Optics.
Setting Wash Speed
1. From the main control screen, select SYSTEM DETAILS
2. Select SPINDLE 1 ON COAT
3. Depress the tachometer power button and aim its light at the blue deflector cup and
check the speed
a. Adjust the speed to 400 RPM by turning the
potentiometer, located behind the side
access service door as shown in Figure 8,
clockwise to increase or counter-clockwise
to decrease the speed.
4. With SPINDLE 1 ON COAT still selected, select
SPINDLE 1 WASH
5. Depress the tachometer power button and aim its
light at the blue deflector cup and check the speed
a. Adjust the speed to 1800 RPM by turning
the potentiometer, located behind the side access service door, clockwise to
increase or counter-clockwise to decrease the speed.
6. Select SPINDLE 1 WASH to turn it off and select COAT SPIN OFF
7. Depress the tachometer power button and aim its light at the blue deflector cup and
check the speed
a. Adjust the speed to 2000 RPM by turning the potentiometer, located behind the
side access service door, clockwise to increase or counter-clockwise to decrease
the speed.
8. Repeat these steps for spindle #2.
Adjusting the curing lamp time
1. Select MACHINE SET UP button from the Main Screen
2. Select LAMP CYCLE button
3. Measure the length of time for this cycle to complete
4. If the measured time is not 15
– 17 seconds, adjust the lamp potentiometer (see Figure
8) as follows:
a. Counter-clockwise turn of the potentiometer will increase the cycle time
b. Clockwise turn of the potentiometer will decrease the cycle time
Removing the curing lamp
1. Select MACHINE SET UP button from the Main Screen
2. Select LAMP CYCLE button
3. Wait four to five seconds, then press LAMP CYCLE
a. This will level the lamp module for removal
4. Open lamp access panel on back of machine
Figure 8 - Speed adjustment
potentiometers
