Ultra motor Europa, Руководство пользователя

Страница: 13 / 34

Re-install the two bolts/washers through the eyelets on each fender brace and into the
threaded holes in the fork tubes. Tighten each bolt, being careful not to over-tighten,
using the 5mm hex wrench.
Re-install the head light, inserting the attachment bolt and washer through head light
bracket, then through the angle bracket on top of the fender, screwing it into the threaded
hole at the top of the fork yolk. Tighten the bolt securely using the 5mm hex wrench.
Install the Front Wheel
The bike is shipped with the front wheel removed. To install the front wheel, please
follow these steps below.
WARNING: Your Ultra Motor electric bicycle is equipped with a quick
release front (only) hub to facilitate wheel removal and installation. Please
follow the instructions provided for the quick release mechanism to insure
proper use. Failure to properly install this quick release front hub may
result in the inadvertent release of the front wheel while you are riding the
bicycle. This occurrence can result in serious injury or death, and property
damage.
If you are uncertain about any aspect of the assembly and
adjustment of your bike, seek help from a qualified mechanic. A
comprehensive manual for the use and care of your quick release provided
by Shimano (the manufacturer of the front hub) has been added as a
supplement to your Owner’s Manual. Read this excellent reference for
additional instructions regarding this important product feature.
1.
Locate the quick release mechanism that is packed in the accessory kit. See photo
below.
2. Insert the quick release mechanism into the front dynamo hub. Be sure that the
centering springs are positioned as shown, with the smaller ends pointing to the
middle of the hub. Be sure that the quick release lever is on the opposite side of
the hub from the larger of the two flanges as shown. Thread the adjusting knob
only several turns onto the spindle.
3. Position the wheel in the front fork so that the quick release lever is located on the
left side of the front fork.
4. Move the quick release lever to the OPEN position (lever curves away from the
hub) and position the wheel in the front fork so that the axle is located in the fork
drop-outs.
13