the Battery & Charger Instruction Manual (and in Section VIII of this manual) for
at least 8 hours before using the bike for the first time.
Carefully unpack your Ultra Motor bike. The top of the carton can be opened by pulling
the stapled and glued flaps. It is recommended that the staples used to secure the flaps be
completely removed (with a pliers, if necessary), to avoid the possibility of scratching
yourself or the bike as it is extracted from the carton.
With the top flaps open, and the staples removed, carefully lift the bike up and out of the
box. The bike is cumbersome, so it is best to ask a friend to help lift the bike out of the
box. If no one is available, the bike box may be laid flat on the ground such that you can
remove the bike from the box horizontally. If you use this method, take care to avoid
scratching any unprotected surface of the bike on the ground.
When the bike is out of the box, lay it on a tarp or blanket to avoid scratching any
unprotected surface while you remove the packing material from the bike. Remove the
two accessory boxes from the bike carton.
Using the side cutters, clip the zip ties that hold various components to the frame. Clip
only those zip ties that are used to attach components to the frame, or those that are used
to keep components from moving during shipment. There are zip ties installed on the
bike that are used to manage electrical and control cable routing on the bike. DO NOT
clip those zip ties as they are necessary for the safe operation of the bike.
Note: Rule of thumb: the zip ties used to secure the components for shipping are
not trimmed. The ties that must remain on the bike are trimmed of excess length.
Only clip those zip ties that are not trimmed.
Remove all of the protective wrapping from the bike and discard.
Identify the various Parts and Components of your Ultra Motor Bike
Please refer to the illustrations on page 10 or 11 for an explanation of the various parts of
your Tres Terra electric bike.
Install the Front Fender
This procedure may require the assistance of a friend to hold the front fender in place
while you attach it to the bike.
Using the 5mm hex wrench, remove the bolt and washer that holds the front head light to
the front fork. Set bolt and washer aside. Position the head light so that it is out of the
way. Using the 5mm hex wrench, remove the two bolts and washers from either side of
the front fork tubes. Set the bolts and washers aside.
Position the front fender in between the fork legs, with the angle bracket on the top of the
fender. Position the fender braces (the long wire pieces attached to the fender with an
eyelet at the end) in proximity to the two threaded holes on either side of the fork tubes.
12
Содержание Europa
Страница 1: ...Europa Electric Bicycle Owner s Manual 1...