Ultimate Jets
- Diamond assembly manual - Revision 4 - 01/01/2015
16
Place the carbon cover in the appropriate slot on the wing.
Drill four 1 mm holes in the wings for the cover screws position. Check holes position.
If OK, drill the carbon cover at 2.5 mm and the wing pocket at 1.8 mm. Countersink the cover screw holes.
We recommend our 6 flute carbide tool to cut the countersunk hole through carbon fiber.
http://www.ultimate-jets.net/collections/machining-hardware
Check securing with the provided #2 countersink screws and remove.
Locate the flap and aileron control horns. Detach from the machined plate and prepare. The gluing surface
should be scuffed off and drilled as per the pictures below.
