Ultimaker S7, Инструкция по установке и эксплуатации

Страница: 12 / 38

EN UltiMaker S7 Installation and user manual 11
3.1 Unboxing
The UltiMaker S7 comes in reusable, durable packaging, specially designed to protect your 3D printer. Follow the
steps below properly to unpack your UltiMaker printer.
It is recommended to remove the packaging with the box placed on the floor for safety. Please retain all
packaging for warranty purposes.
Location
Before unboxing, choose a suitable location to place the UltiMaker S7. Take the following into account:
• Install the product on a flat, level, and stable surface that is capable of carrying the printer’s weight
(~ 35 kg / 77 lbs).
In combination with the Material Station, the total weight is up to 57 kg / 126 lbs.
• When placing the printer on a shelf or table, take proper measures to prevent the printer from falling.
• The UltiMaker S7 must be positioned out of direct sunlight when in use.
• Ensure there is at least 10 cm of space behind the printer for unrestricted airflow.
Unboxing instructions
The UltiMaker S7 must be lifted by at least two people during installation.
If the printer needs to be transported without the outer box, be aware of the weight and dimensions of the
printer. Use proper transport means to do so this safely.
If the UltiMaker S7 is going to be installed in combination with the Material Station, place the Material Station
first. Place the UltiMaker S7 on top of the Material Station and ensure the two products are correctly aligned.
1. Open and remove the six plastic locking clips from the bottom of the
packaging. Do not cut open the box at the top.
2. Slide the outer box upwards off the printer.
3. Remove the top cardboard cap from the top of the printer.
4. Lift the printer out of the bottom tray. This must be done by at least two
people. Place one hand in the handle in the side panel, and another on
the back panel for stabilization.
5. Place the printer on a flat, level, and stable surface.
6. Remove the rubber door seals and open the glass door.
7. Pull the cardboard box marked Starter pack forward and out of the printer.
8. Remove the two cardboard inserts from the left and right
side of the printer.
9. Manually lift up the build plate and remove the cardboard
insert from underneath it.
Starter pack
1. Open the box at the top.
2. You will first find the printer documentation, including the quick start
guide and safety and warranty information booklet.
3. Underneath the top insert (place this aside) is the flex plate.
4. You will then find the accessory box, containing the print cores, spool
holder, lubricants, etc.
5. Beneath the accessory box are the spools of Tough PLA Black and PVA
Natural and the filter for the Air Manager.