Ultimaker 3 Extended, Инструкция по эксплуатации

Страница: 11 / 21

3D PRINT - Ultimaker Extended 3 CHAPTER 2. MATERIAL
.
1 : spool holder - 2 : spool material 2.
Make sure that the spool material is in clockwise direction.
.
• Check the shape of the tip of the material. If it doesn’t look good, cut the tip
of the material.
.
•
Insert and push the end of the material 2 into the feeder 2. Push the feeder
knob through up 2 and at the same time, pull the material 1 .
.
1 : Feeder enter - 2 : Feeder knob.
•
Confirm by pushing the button at the front side of the 3D print when you
have inserted the materiel.
10