UINICS LV1000 Series, Инструкция по эксплуатации

Страница: 29 / 67

- 25 -
“ 9999 blink”・・・・・・・0％ output
Moreover, also when an analog input signal becomes the following conditions, it becomes
0％ or 102.4％ of output compulsorily.
When a indication will be “
－ － － － － blink” by “Input signal ≦ -20％F.S.”
[Disconnection detection]
≪Method of operating key to scaling setup≫
Operation key Display The contents of operation
Ａ Ｂ Ｃ Ｄ Ｅ
０ ０ ０ ０
１ ２ ３ ４
● ○ ○ ○
Hold %
○ ○
Setting value is switched whenever it presses a
<Minimum value>→<Minimum analog input value>→
<Maximum value>→<Maximum analog input value>→
<The indicated value at moment of 0.0%>→
<The indicated value at moment of 100.0%>→
<Domain 0 minimum indicated value>→
<Domain 0 maximum indicatedvalue>→
<Analog output minimum value>→<Analog output maximum value>
The lamp corresponding to each setup light up and blinks
at the time of a change.
Setting of minimum value. OUT1 light
Setting of minimum analog input value.
OUT1 blinks
Setting of maximum value. OUT2 light
Setting of maximum analog input value.
OUT2 blinks
Setting of indicated value at moment of 0.0% ％ light
Setting of indicated value at moment of 100.0% ％ blinks
Srtting of domain 0 minimum indicated value.
OUT3 light
Setting of domain 0 maximum indicated value.
OUT3 blinks
Setting of analog output minimum value.
OUT4 light
Setting of analog output maximum value. OUT4 blinks
Ａ Ｂ Ｃ Ｄ Ｅ
→ ０ →０→０→０
↑ ↓
└───────┘
１ ２ ３ ４
● ○ ○ ○
Hold %
○ ○
Moves the flash figure when each setting, to the right.
Please match it to a set value of hope using it together.
Mode
Mode