UINICS LV1000 Series, Инструкция по эксплуатации

Страница: 26 / 67

- 22 -
Analog input value
10V
5V
-1000 0 2000 5000
Rate meter indicated value
[Example of setting]
The analog input A5 (0 to 10V) range.
At analog input value (0V), the indication value is (-1000).
At analog input value (10V), the indication value is (5000).
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Minimum indication value ● ○ ○ ○ ― １ ０ ０ ０ （－１０００）
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Analog input value of minimum indication ◎ ○ ○ ○ ０ ０ ０．０ ０ （０．００Ｖ）
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Maximum indication value ○ ● ○ ○ ０ ５ ０ ０ ０ （５０００）
１ ２ ３ ４ Ａ Ｂ Ｃ Ｄ Ｅ
Analog input value of maximum indication ○ ◎ ○ ○ ０ １ ０．０ ０ （１０．００Ｖ）
Ａ Ｂ Ｃ Ｄ Ｅ
Mode No.0 ０．Ｘ Ｘ ０ （Decimal point position“0”
）
●・・・Light up. ○・・・Light disappears
◎・・・Light blinks. Ｘ・・・Arbitrary setting value
The indication is shown in the figure below. Fig.15
【Ratio indication value：№⑤-⑥】
The indicated value at moment of 0.0% and the indicated value atamoment of 100.0% are set up.
It indicates ratio by the inclination which connected two points. And O to 100% LEDs turn on a
nd off according to the rate value every 5.0%. *Calculating from 0.0 to 4.9%
All LEDs of the bar display will turn on and off when over 100.0% (100.0 to).
The least significant digit will turn on and off when under 0.0% (to -0.1%).
Setting range：-9999 to 9999 <A decimal point is interlocked with the mode No.0>
＜Csution＞
When it sets to <The indicated value at moment of 0.0% ＝ The indicated value at moment of
100.0%>, “999.9”carries out flashing.
[Example of setting of ratio]
The indicated value (-1000), the indication ratio is (0.0%).
The indicated value (5000), the indication ratio is (100.0%).
％
HD ＯＶ Ａ Ｂ Ｃ Ｄ Ｅ
The indicated value at moment of 0.0% ● ○ ○ － １ ０ ０ ０ （－１０００）
％
HD ＯＶ Ａ Ｂ Ｃ Ｄ Ｅ
The indicated value at moment of 100.0% ◎ ○ ○ ０ ５ ０ ０ ０ （５０００）
！