UINICS LV1000 Series, Инструкция по эксплуатации

Страница: 7 / 67

- 3 -
Cisconnection detection
function
It is judged that it disconnects when becoming ｢Input signal≦
-20％F.S.｣ Rate mete and ratio“
－ － － － － blinking”
(A2,A3 type)
※ The disconnection detection can be output from OUT4(Option)
EXT. input
EXT input function
Hold/peak hold/bottom hold/width of input/0 adjustment
function.（
“mode №3” selectable）
The rear terminal board (6-7) is ON. 50mS or more is ON.
(HD turning on the lamp）
Input NPN open collector pulse input or ground contact.
Preset
output
Output terminal Output terminals no.1-2-3 (OUT1),14-15-16 (OUT2)
Comparative system Upper limit, lower limit (immediately) and lower limit
(delay). (selectable)
Output mode Comparison, maintenance,(selectable)
Output selection Function stop, Rate mete, Raito,(selectable)
Preset value setting The presetting program mode setting is also selectable.
Output judgment
Judgment output is compared with the indication value by
preset value.
Output circuit
Tow-row relay 1c output
[ Control capacity / Maximum permissible power ]
AC125V 0.6A （Resistance load）
AC250V 0.3A （Resistance load）
DC 30V 2A （Resistance load）／60W MAX
[ The maximum control current ]
2A MAX
※ Can be used within control current 2A and control capacity
/ permissible power.
Output indication During presetting output, the OUT1 and OUT2 LED are activated
Output reset
The key to the pushed for 2 sec or more.
Hysteresis setting 0-3999 (4 digits to disregard decimal point)
Hysteresis operation
Invalid or selects it from effective.
※ When the output mode is only“Compareson”,it operates.
Preset output state
distinction time It outputs it continuing set time (0.0-99.9 sec) after it
enters the output area at the output area.
Data backup Each mode stting value is memorized by FRAM
(The memory number of times is within 100,000 times,
About 10 year safekeeping.)
Others
Mode protect function Changes by mode protect function setting.
“L-oFF”is possible to change by setting.
“L-on”is not possible to change by setting.
Warm up time After turning on the power, more than 30 minutes.
Power source AC85-264V (50/60 Hz)
DC-type DC12-24V (±10%)
Power consumption Approx. 23VA
DC-type Approx. 10W
Temperature/humidity
conditions 0-50 ℃, 30-80 %RH (Non-condensing)
Weight/dimensions Approx. 370g, W96×H48×D130mm
Material of the case ABS
Color Gray
K-type Black
Protection class IP66
／75VA MAX
RST